Molyslip Flaw Crack detector kit

Share on Facebook
Cetak
Lihat Ukuran Penuh

Lebih detail

Info lainnya

Molyslip Flaw and crack detector set includes a 3 part system 400ml Clean and prep 400ml super penetrating Dye and 400ml developer.
Cleaner
Highly efficient rapid drying general purpose cleaning solvent
Low toxicity and does not cause corrosion of metals
Removes oil, grease and dirt and also residual penetrate

Penetrate
High performance red dye penetrate to indicate cracks and flaws for non-destructive testing on metal surfaces or welds, much more accurate then pressure or leak down testing, shows even the smallest flaws scratches, micro cracks, points of metal stress, and where metal is porous or has become pitted not normally visible.
Developer
Highlights flaws, faults and cracks in metal surfaces
White talc film will cling to and be stained pink by any surface imperfections to give precise definition of faults
Replacing a Head, intake or exhaust manifold, engine over heated blow head gasket, doing a performance mod.

Before you put in the money and hard work of making that major change repair or race ready modification make sure the head, manifolds block cylinders pistons, valves, turbo or super charger is in tip top shape.

I have been working on all sorts of engines for just about 30 years and have on too many occasions found out after putting in the money and hours of work, a cylinder wall was scored, a block cracked, someone had over torque'd, or a Turbo that has been heat stressed and so on.
So after up and running only to find problems and have to take it all apart again.
I always wished I had checked it first.
This kit and 10 minutes could save any mechanic or race builder thousands of pounds and days of work.